The fit of fixed partial dentures joined by infrared soldering

Gerard Byrne, Leon W. Laub, Jenq Yong Hu, Martin F. Land

Research output: Contribution to journalArticle

14 Scopus citations

Abstract

This study determined the accuracy of fit of three-unit fixed partial dentures joined by an infrared soldering technique compared with one-piece fixed partial denture castings and individually cast crowns. Wax patterns of prepared Ivorine teeth, maxillary left central incisor and maxillary left canine, were injection molded; a plastic rod was used as a pontic. One group of patterns was cast as one-piece dentures; the other group was sectioned in the connector area, cast individually, and then joined by infrared soldering. Castings were seated on their respective dies, embedded in epoxy resin, and sectioned. Gap distances between the casting and the die were measured at specified marginal sites with a profile projector. Results showed that the fit of infrared-soldered fixed partial dentures was significantly better than that of one-piece castings and was comparable with the fit of single crowns. The gap openings measured in all castings were within the range of clinical acceptability.

Original languageEnglish (US)
Pages (from-to)591-596
Number of pages6
JournalThe Journal of prosthetic dentistry
Volume68
Issue number4
DOIs
StatePublished - Oct 1992

    Fingerprint

ASJC Scopus subject areas

  • Oral Surgery

Cite this